Squirrel Stopper™ assembles in minutes without tools!
Printable Installation Instructions

1. Set auger onto ground and screw lower section into ground.

2. Twist and lock middle section with attached shroud onto lower section.

3. Slide 1" horizontal tubes through holes in top section.

4. Twist and lock top section onto middle section.

When properly installed bird feeders should hang between 5' and 6' off the ground.   Squirrel Stopper™ includes: Decorative cardinal top or finial top Top holder 2- 1" outside diameter cross tubes 4- eyebolts and nuts for hanging feeders 3- 3' x 2" outside diameter tube sections with "twist and lock" attachments Squirrel Stopper™ shroud (factory-attached to middle tube section) Steel Auger

Hang your bird feeders and start feeding ONLY the birds!

All content and photographs on this site are the property of Squirrel Stopper, Inc. Content and photographs may not be copied or used without express written permission copyright infringement will be strictly enforced. Copyright 2008